What is the base?
FOLSING FASE is a protective cover applied to the wall at the point where it meets the floor. The basic formation, which is primarily designed to protect the base of the wall from damage, if affected by furniture and other objects, also provides relatively easy access to the area behind the wall when the gap between the lower edge and the floor of the wall remains. While the wood strip of about 4 inches (10.16 centimeters) is wide is everything that is generally necessary, decorative accessories are added to almost all residential applications and also in most commercial applications.
When the inner walls are built in the structure, they are usually made of attached plasterboard on vertical wood or metal rays called studs. In many cases, the ceiling height is actually slightly higher than the standard 8 feet (2.44 meters). When this is the case, the plasterboard is included on the ceiling that has already been installed, and there was a gap between the walls and the floor. The formation of the base is necessary to hide this gap. In a nourishment if the future work of the requestAdvanting access, it is sometimes possible to simply remove the motherboard, rather than trim the hole in the wall itself.
While plasterboard provides the structure for the interior space, it is not too strong. When it interferes with a piece of furniture, or easily breaks, or many other objects such as vacuum cleaners that are powered by force. Although the plasterboard does not break, a sharp wound, like a hammer, crushes the plasterboard content, sometimes breaks the surface of the paper and leaves unsightly thoroughly that will require repair. Given that the chances of such harmful contact are the largest near the floor, due to movable furniture, the base is normally installed, even if it is not hidden.
walls in residents and some commercial spaces are often also protected by a rail called railway rail, which is a strip of wood or plastic from 4 inches (10.16 centimeters) wide up to 6 inches (12.7 centimeters) wide, installed between 32 inches (81.28 centimeters) and 40 inches (1.016 meters) from the floor to protect the wall from damage that could be caused when chairs are in contact with the wall. Most residential applications also have a formation installed, where the wall meets the ceiling, but this is a decorative nature.
The basic rails of commercial spaces are generally not as decorative as the area found in residentials, and often consists of anything other than a piece of flexible pressed plastic, which is attached to the wall using glue. These basic rails are extremely hard and durable and resist the impact of cleaning equipment and the furniture moves even better than their wood counterparts.
Installation of the formation of the basic bar is relatively simple. In most cases, the most important element is a plate that measures 0.5 inches (1.25 cm) thick by 4 inches (10.16 centimeters) Wide, cut into a length for the wall to be installed. If the wall is too long to one lengthThe boards, two pieces are connected by a simple joint of the butt. Once the main element is installed with its lower edge in direct contact with the floor, additional pieces are added. In many cases, a single quarter piece will be installed, where the bottom edge of the base meets the floor and on the upper edge of the base is installed another quarter round, sometimes Ogee and sometimes another character. There is an almost unlimited selection of designs from which you can choose, and there is no requirement for the main element to be a 4-x 0.5-inch (10,16- x 1,25-centimeter) board if the main purpose of the joint protection where the walls are met. Once installed, the formation of the base is either colored or painted.