What is wet blasting?
also known as porridge blasting, wet abrasive blasting or wet sand, wet blasting is a method of cleaning the explosion that uses sand and water in the process. Over the past decades, other elements have been used or along with sand, including plastic or ceramic balls. This approach is considered safer than drying methods because the amount of air particles is reduced. In many cases, this form of blasting is ideal for cleaning various types of masonry, including bricks, sidewalks and concrete walls.
One of the main advantages of wet blasting is the simplicity of the process. By combining sand with water, it is possible to create a steady stream that bombs the surface of some type of masonry, relaxing dirt and other mass from the surface. The abrasive effect of this method is highly effective because it actually cleans the surface before it simply applies some type of cleaning agent to the masonry. The final result is a surfeso that is no dirt.
Most devices designed for use in wet blasting include controls that help manage the mixing of water and sand in a way that is considered suitable for the type of material to be cleaned. Higher concentrations of sand in water can be ideal for situations where the surface of the masonry is as often with bricks. For relatively smoother surfaces, a smaller amount of sand per gallon of water can also.
routing the flow of water and sand, which is sometimes known as a porridge, is usually managed using a high -pressure hose. This allows you to control the angle and a current directed to the surface, allowing cleaning to be clean in the most effective way. Usually there are also equipment that can be used to remove the number of numbers from the location, usually by using a type of suction hose to collect sand into the holding tank. Many companies providing this type of service can also handle cleaning after completing work, allowing an area to beLa visually attractive than it was before wet blasting.
Wet blasting is often used to remove dirt from sidewalks, outer walls of buildings, or even free -standing walls that close residential and commercial real estate. The same general process is sometimes used in the manufacture of different types of metal components that effectively remove residues from recently produced parts before they are checked and packed for sellers for sellers and customers. It is not unusual for metal components that are about to recycle or reconstructed to be exposed to wet blasting, so the task of preparing the components for further use much easier.