How can I choose the best float?

If you want to choose the best float for your project, you should consider what types of grouting materials and tiles you use in what area you work and several personal preferences. Many projects will use a standard rubber grout, but the properties of non -standard floats can have a big difference when you need them for certain materials. Flocks of grinding surfaces made for work in specific areas can be invaluable when trying to get good coverage in hard -to -reach places. Once you have basic options, there are only a few other options that need to be considered mainly to personal preference.

Standard joints of the grout are usually made of rubber, have a rectangular shape and can be used for most basic projects. However, when you start using a more specialized material, another type of jointing floats may be required. One such float is the float of stone grout, which is used in tiling with natural stone. NatureThe stone can be damaged more easily than the tiles and you have to make sure you have a stone float with a softer surface to prevent scratches and brands.

Another tiling material that guarantees its own type of jointing floats is an epoxy grout. This type of grout is generally much more sticky than a conventional cement grout and can be difficult to work. When using an epoxy grout, you will want to have an epoxy grout that will make it easier to spread. This is usually achieved by complicating on the float sides, so the sticking on the grout is resistant.

6 In these areas, the float will be very useful. Offset floats have the handle set back to one end, unlike the centered. This gives you a longer tip that you can get under the edge of the cabinet without hand or handle in the way. These floats are often a little narrower thanStandard floats that also help to get into small areas.

The float on the edge is similar to the indented float in that it can be invaluable for achieving small or obstacle areas. This type of float is also narrower, but the handle is attached to the back instead of the upper part of the float. This design would be very difficult to use if you need to exert even pressure and cover a large area, but it is perfect when you try to fit into a small, defined space. This type of float fits into otherwise obstacle areas and is also good for repair when you need to target a very specific space in the joint.

6 For example, the traditional float design has a D -shaped handle concentrated on the upper part of the float. They also have a version where the handle is open on one side and designed to be ergonomically useful. The back and handles can be made of various materials such as plastic, aluminum and wood. These options can change comfort and durability butBasically, all work in the same way in terms of effective completion of your project.