How can I remove mold on Sheetrock?
Removing the mold on Sheetrock, which was previously prepared or painted, is a relatively simple procedure. Before you start, find the moisture source and cause it and remove it to prevent future mold growth. If you want to remove the existing sheetrock mold, you will need to mix one part of the bleach of chlorine into four parts of water. After dressing the protective equipment as needed, apply the Sheetrock solution using a sponge or spray bottle. After removing the mold, rinse and dry the surface well and apply the paint or stain to the surface before repainting the surface.
Before removing the mold on Sheetrock, you should check the surroundings to determine the cause of the mold. Any leaks on the roof or plumbing should be repaired to prevent the mold from being repeated. If the form is caused by condensation, you may need to install a dehumidifier in the room. If sheetrock has been saturated or damaged with water, it will probably need to be replaced. A professional may be necessaryé eliminate extremely large areas of mold on Sheetrock to prevent the spread of spores to carpets, curtains, furniture or pipes.
It is important to protect yourself from disturbed spores by wearing a respirator during the form removal procedure. You will also need to wear latex or vinyl gloves to protect the skin from chlorine cleaning solution. Correct ventilation is necessary during this procedure; Open as many doors and windows as possible before starting work. If you work on the top areas, you will also need protective eye wear. Cover the floor and surrounding surfaces with plastic foil to prevent carpet, floors or furniture.
further, create a chlorine cleaning solution of one bleach for four parts of water. You can mix this solution in a plastic bucket or spraying. Apply the solution to the Sheetrock, wait 15 minutes and scrub with a sponge, soft brush or a cleaning cloth.Repeat this process using fresh chlorine and washing machine solution until the mold is completely removed. Use as little chlorine solution as possible to avoid the Sheetrock surface saturation.
After you have successfully removed the mold, rinse the sheetrock surface thoroughly to remove the rest of the chlorine and use a slight cleaning agent to prepare the surface for activation and painting. Dry the Sheetrock with a towel or a blowing dryer. Discard all plastic foils, cleaning substances, brushes and mushrooms used during the form removal process to prevent re -growth. If the area is still wet from the previous water leakage, it is good to place the dehumidifier in the room a few days before the painting. Finally, apply a stain or seal to the Sheetrock.