What are the strips of the book?

Book strips are elements of structural support elements used in the construction of wood and cabinet production. Typically, the book belt is typically a square length of wood connected horizontally to a vertical surface that supports one end of the shelf or beam. Three or shelves are then supported at their opposite ends by the second band of the book or other type of support mechanism. A critical part of the book's belt is the correct number, type and spacing of fasteners used to connect the strip. Nails or screws generally attach book strips to the posts and a safe diameter for numbers and gaps is the location of one fastener under each beam. Strips are generally square in cross -section and are located at both ends of the building element that support. When used in the construction of wood induszku, the strips of the book are generally attached to the book. It is a flat length of wood anchored to a wall or frame, which is used to spread the loads of the beams evenly. There is a whole ŘAda ways to attach beams to the book, including nasal hangers or strips of the book.

The beam caterpillars are pressed steel frames and shaped to receive standard size beams. These images are screwed to the book and the beams slipped into them for support. The smoke belt is a simple square wood strip screwed or nailed on the board of the book, on the top of which they wear. Three ones do not have to have any profiles in them and simply rest on the top of the strip, thereby introducing against the book. They may also have a square profile cut out of their ends to match the size of the book belt, which then rests on the book belt and offers a safer placement of the beam.

Wrips

are often found in cabinet production and buy as an alternative for pegs or shelves and cabinet support holders. These strips are simply nailed or screwed into a placeIn the position of the shelf and the shelf plate placed on them. In both cases, the correct types of fasteners and their gaps are decisive for the integrity of book strips. Although the types of fasteners and their gaps differ from the task to work, it is generally acknowledged that the strings of the bearing noses of the bearing noses have three fasteners in each position of the beams with one placed directly below the beam. The smoke strips that support the shelves should have one fastening element at both ends and one evenly distributed, for every 25% of the remaining length.