What are the best tips for installing deformation?

The three most common types of plates are tiles, pre -axles and solid surfaces. Their installation is quite similar, although the medium is different. Preform, which is a composite wood covered with laminate, provides the simplest board installation, while solid surfaces are among the most difficult.

Most experts recommend against amateur installation of solid surfaces such as granite. Installation requires special tools that the average weekend warrior would not have at hand or experience in use. The already exaggerated cost of a solid surface could be significantly increased by slipping the saw that destroys the piece. For the average house owner "do it yourself", granite tiles are an attractive alternative to a solid surface.

Installation of preliminary forform is the easiest choice. The pre -ancestors can be limited to the correct measurement of the highest measures of home improvements by measuring the old deformation board and are the best options for cutting accurate angles for corners. Once appliances and sinks are removed from the oldPlates can be placed above it with craft paper and used to monitor the sink holes and any strange angles. The old plate can then be unscrewed from below and raised in place.

Place the new board correctly. Use traces of craft paper to distribute the sink hole and puzzle to cut it out. Be sure to always wear safety glasses because the laminate peak could have a chip and fly. Replace all screws that held the old plate in place and make sure to seal along the backsplash to prevent the water from entering the back of the counter.

Tile begins with the same installation process. Use the same method as above to cut the surface for the tile using a 3/4 inches (1.9 cm) plywood and a sink opening. Use 1/2 inches (1.27 cm) bolts to screw in pieces of non -porous cementcuds of the supporter via plywood to prevent deformation fromwet mortar that will follow. If you also surround backsplash, screw the same cement support to the desired wall area.

Using a war trowel, the Thinset Malta layer, which works in a two -foot box (0.61 meters) at a time. Do not forget to choose the right mortar, because each is evaluated for a different job. Place the tiles on the mortar by means of the tiles to reach the right gap between them. Once the tiles are dry, it writes them using a joint float and wipe the excess with a damp sponge.

In order to complete the board installation, the counters can be completed by selecting a tile or wood. Bullnose tiles work nicely to limit the edges, while the wood colored to match the cabinet can be quite beautiful and joining the kitchen together. Once all the tiles are laid, injecting and dried, wipe with a dry cloth and enjoy a new surface!

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?