What are the best tips to repair the toilet for handymen?

DO-IT-HYOUSELF (DIY) Repair toilet is a relatively simple process that the average homeowner can complete within a few hours, with most of the time to diagnose the real problem and buy spare parts. There are only a few moving parts in the toilet and the destination where the problem lies, requires a quick check of each of them. If the water flows from the upper tank to the bottom, it is usually necessary to adjust or replace the defective stem valve. On other occasions, the toilet may continue running internally, even if the water leaks to the lower tank and this situation would require a float replacement or corresponding to shutdown. Most of the time experts to repair the toilet for handymen recommend replacing all the inner parts for the first sign of the problem because they are cheap and relatively easy to replace.

The first thing you need to check when the toilet repair is completed is the water level in the upper tank because if too low is set, it is possible that there is insufficient pressure on managementno flushing. If this is the case, there is usually manual settings that can be rotated by hand or screwdriver; Anti -clockwise, the inner water level should increase, while turning in the opposite direction would reduce it. After this adjustment, the toilet should be rinsed again and the entire cycle should be observed to ensure that the stop valve closes correctly and the toilets are complemented in a quick manner. At this point, the toilet should flush perfectly and turn off at the right time; If this is not the case, individuals should replace the internal parts.

Before starting any project repair project, it is important to turn off the incoming water either at the closure switch on the toilet water line or to the main valve outside. Once the steps out of the way, individuals can rinse the toilet and allow all the water from the upper compartment to release. The towel can be used to collect any excess water that remains in the upper tank and once universityE dry, it is possible to remove any damaged inner parts.

Now that the water is correctly disconnected, the next step of repairing the toilet for the handyman would be to remove the screw that holds the refilling mechanism on site. It is usually located under the upper tank and can be rotated with a standard pliers set; Once the nut is removed, the entire valve should rise directly from the toilet. The remaining parts are easy to relax and from that point on the instructions can be monitored to install new toilet parts. If the toilet repair for the handyman still does not run out, it is possible that the wax ring under the toilet or a return pipe leading to the septic tube is damaged. The wax ring can be installed by unscrewing the anchor screw and lifting the entire toilet from the floor - the drainage line would require professional help.