What are the best tips for plasterboard repair?

There are some tips that can save time and trouble when repairing plasterboard. The cracked or persecuted areas can be corrected by applying several thin layers of the joint compound to the surface. Self -adhesive, metal bridges and articulated compounds can be used for medium size repairs. The handles for handles are easily repaired by a specially designed plastic patch. Large areas must be cut and replaced by new plasterboard. Buy a small container of joint mixtures, a wide sealant knife and a leaf of fine sanding paper from the hardware store. Apply a thin layer of compound to the plasterboard and allow it to dry. Guarate the patch patch until all the combs and imperfections are removed. Repeat this administration process until the damage disappears. These bridges provide the robust pad for the joint to observe and sell in different sizes. Before installing the metal bridge, it slightly grinds the surface. Apply several thin layers of joint compounds with a wide sealant knife. EachSmooth the joint compound layer with fine sandpaper until the patch corresponds to the surrounding plasterboard.

The repair of the plasterboard, where the handles breaks, can easily be done with a circular plastic patch. The specially designed repair not only covers the hole, but also helps to prevent future damage. Before installing the plastic repair, the area around the hole must be clean, smooth and dry. This repair patch is equipped with a foam insert supported by glue for secure installation. It may be a good idea to install this type of repair before damage.

Large areas of damage usually require special tools and procedures for professional results. The repair of plasterboard through these large areas is usually performed by removing and replacing the damaged part. In addition to the sealant knife, grinding paper and articulated compounds, the measuring tape, a saw for a keyhole, box cutters and plaster screws will be requiredTon. There is usually a low emptiness between the inner gypsum mattness and the outer sheathing. This emptiness contains wooden frame boards, electric wires and plumbing tubes; Therefore, it should be careful when cutting.

with a keyhole cut damaged plasterboard in each horizontal direction up to 1 inch (2.5 cm) vertical frame plate. Replace damaged plasterboard with a new piece of material that has the same dimensions and thickness. Cut the new piece of material with the box cutter and connect it to the framing plates of the drywall screws. Before connecting a new piece, make sure that the finished side is facing the room. Apply several thin layers of joint compounds to seams and sand between each application.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?