What are the best tips for irrigating the greenhouse?
The greenhouse irrigation allows gardeners to maintain most of the greenhouse than it would be when watering. Preferred methods are irrigation of spray and drip, although irrigation drops are more popular. The greenhouse must be measured before the addition of various irrigation lines between planted rows. After creating the holes, attach the irrigation hose to the main hose and use a valve or adapter plug. Stir the head assembly to the main comic before slowly turning the water.
Spray irrigation is best used on greenhouses with pots from pots, while irrigation of drop should be used for greenhouses in the ground. It seems that irrigation drop is a preferred option for the greenhouse owner because it is easier to install. The drip irrigation is also more efficient than its spray counterpart, as it can be modified to include a larger number of plants. There is also a lower speed of evaporation with irrigation irrigation.
Measure the necessary irrigation length. Every crawlThe NTED requires the irrigation tube the length of the greenhouse. For successful irrigation of the greenhouse, where the rows are planted far apart, it may be necessary to insert several tubes apart about 12 inches (30 cm).
To connect the watering tube of the greenhouse to the main tubing, an adapter plug is required. The valve plugs can be a better choice if the greenhouse owner wants to control the amount of water that reaches each single line. Je to proto, že na konci každé řádky lze zapnout a vypnout zástrčku ventilu.
The next step is to measure the greenhouse width as well as the distance between the greenhouse and the water tap. It is necessary to use non -franked hoses for the water supply process into the greenhouse. If you do not do so, it will result in dripping water on the floor along the road. This tubing must be large enough to supply each irrigation line of sufficient test.
The strength to be connected to the main tube. This is achieved by creating holes in the main tube to fit in the irrigation lines. The valve or adapter connectors must then be put in the main tube. The irrigation lines should be located at the end of these plugs. The end closures should be placed at the ends of the irrigation lines to ensure sufficient pressure to force the water from the holes.
The main tube must be connected to the head assembly after this assembly was threaded on the main faucet. Slowly turn on the faucet because too much water will damage the irrigation line. Irrigation of the greenhouse does not require much water. Pokud voda stříhá z otvorů, byl aplikován nadměrný tlak.