What are the best tips to replace the toilet?
There are many sound tips to replace the toilet to help amateur maintenance complete this task with minimal failure. One of the largest obstacles in this project is to repair or replace the floor if water has been damaged. Once completed, the installation of a new wax ring ensures that a tight seal is made to prevent future problems. Another tip for replacing the toilet is to ensure that it is completely at the level when installing the final assembly hardware. Once the toilet and floor material are removed, there is a great chance that there will be areas that will have water damage that will have to be repaired. If the areas damaged by water are smaller, they can be split and filled with an epoxy designed for wood and a fibrous plate. When the damage is more important, it is often easier to remove and replace the entire floorboard that rests on toilet.
jaIn the floor, the floor floor section is brought according to the standards, the installation of the wax ring is the next step when replacing the toilet. As long as the cut -out where the previous wax ring has been installed, it is in good condition, the rings can be replaced by lifting the old straight up and running a new one. The biggest factor is the location of the new toilet directly through the wax ring and starting to the place with the least possible adjustment. Each side movement reduces the overall efficiency of the ring and increases the chances of future problems.
After installing the wax ring and the toilet sits above it, the next step to replace the toilet is provided on the floor. In some cases, the toilet can cope with previously drilled holes, but it is often better to drill new to ensure maximum stability. While the holes can be drilled from the top of the floor, often it is necessary to have the other person the fiber of the screw over the floor. Once each screw is tightened, the toilet should be checked to ensure that it is at the seating level; AfterWhich is a bit off, the toilet does not have to properly flush and the wax ring can be damaged.
The final procedure for replacing the toilet connects the water pipe. If the hardware is compatible, this step should take only a few minutes. A new water line to the bottom of the toilet can be connected from the shut -off valve. If the shut -off valve is old or does not spill, it should also be replaced in advance.