What are the best tips for pouring colors?
one should not assume that pouring color is an exceptionally easy task. Especially heavy cans of colors are difficult to handle and the error can lead to spilled color. Use a protective cover leaf, preferably plastic before creating a hole in the tin. Screw the discharge into this hole, lift the can and carefully pour the color into the tank. Pouring colors from a small can is almost the same except that the lid is easier to open. In both cases, one should clean the discharge to prevent clogging.
pouring colors is one of the persecution that is not as easy as it seems. The prevailing view is that pouring the color from the tin to the tray is a task that can be done without any problems. This ignores the fact that the color is spraying and giving a mess if it is poured perfectly into the tray. While most problems occur when the color is poured from a large can, even small cans can cause problems.
Before pouring the color of a large can, a protective cover like a sheetplastic. If it ends up on the floor, it should be large enough to contain a large can of color. Then the roll of paper towel, discharge color and color tray can be placed.
A large can of color will have a plastic cap that should be removed before pouring. CAN should be placed so that its unlimited hole is facing the tray. Painting should be inserted into an unlimited hole and twisted until it is seated properly.
large cans of colors can weigh up to £ 44-55 (20-25 kilograms), so the legs should be used to lift it and the back should not be rounded. Tilt the can so that the discharge begins to pour the color into the tray. Once the magazine is filled as much as needed, paper towels can be used to erase any color that dripped from the bucket outlet. Immediately rinsing with warm water, ensuring the paint does not dry inside and clogs.
A screwdriver can be used to lift the lid for a smaller can. Insert the discharge as before and make sure it is facing the magazine. It is easier to lift a small can, but the principle remains the same. The casting rate should be maintained slow and stable. Again, wipe the excess color and rinse thoroughly.