What are the best tips for pruning Gardenias?
Although it is sometimes necessary to prune gardening, the shrub generally makes a relatively good job to take care of itself under the right conditions of cultivation. There are only a few common reasons for pruning Gardenias, including aesthetic reasons; remove dead, sick or damaged branches; And prevent the plant from becoming too long. It is important to prune Gardenias after the flowers died and the flowers died, although this time it can be difficult to determine, because some varieties have been cultivated to unpack during the season. While pruning Gardenias in the right way can help them, cutting branches too short, too aggressively or too roughly can hurt the shrub or kill. For standard varieties it should be sometime at the end of the summer season or early autumn. This is the time when Gardenia ended up in the spring of the spring and starts to store energy for growth. Between the flowers of the current season died, there is a time window and after the Gardenias pruning, the buds are created next season. In the case of Gardenias, which bloom several times during the summer, they should be detained and trimmed after the last cycle of the flowering cycle.
When pruning Gardenias, three types of branches should be found. The first are dead branches where there will be no new growth. These are trimmed not only for aesthetics, but also because they can be a gate for diseases and pests. The same applies to damaged stems, which should also be removed. Patients should be cut to prevent the problem from spreading to the rest of the plant.
Gardenias are generally dedicated to pruning. The cut branches should not be up to 6 inches (about 15 centimeters) of the base, because it will cause the branches to be too short to provide all nutrients or energy to the plant, as well as the diseases and pests to abbreviate to the most sensitive area of the Gardenia. It should also be noted that the shrub will perform a new growth on both old, woody brown stems and newGreens, so cutting of both types is acceptable and brown stems, which are still flexible, should not be considered dead.
The type of pruning used when pruning Gardenias can also change. The type of pruninger it should be used is called a obtok and has two sharp blades that act as scissors. It is necessary to avoid anvil or compression pruns, as it basically crushes the stems and can leave a crushed cut where diseases can enter. Gardenia could also have problems with recovery from such a cut.