What are the best tips for installing water heaters?

Installing the water heater is a relatively demanding task that requires only a few tools. Water heaters can be operated by gas or electricity. When installing or replacing the old water heater, it is important to consider the type of service available in the home and which species has the best sense. Other factors that need to be considered before buying the water heater itself is whether it is for appliances, such as a dishwasher or a jet bath or whether the home electrical system can handle another power input of a larger water heater.

Installation of the electric water heater can take anywhere from two hours to 45 minutes - depending on the installer's skill level. The first step before the start of the process is to turn off electricity. After removing the old water heater, place a new water heater in place. The level of the carpenter will be useful to ensure that it is level. Glittering, either plastic non -brave, are a great way to equalize it.

next, onThe end of the cold water supply pipe, swee the shut -off valve with sweat. This can be done with a propane torch. The wood block is sometimes useful to support the shut -off valve when it is soldered. It is essential that the valve is open in the open position. Basically, the propane torch melts the metal so that the two pieces are firmly attached.

Then take the heat and hot heaters to the cold and hot heaters and wrap the fibers using the TEFLON® tape or stretch the threads with a pipe. Once this step is completed, it is possible to connect to the inputs of cold and hot water - the blue assembly goes to the input of cold water and the red assembly goes to the input of hot water. After the fittings are on the spot, they should be tightened with the key.

The water supply must be installed further -flexible are usually required by code, especially in areas that have an earthquake. Simply connect the supply pipe from the pipe to the water heatery. Then turn on the main closure and open the valves. Do water from all faucets in the house until the water flows without stimulus. Next, turn off the faucets again in the house.

Finally, remove the electrical access plate and connect the electrical power supply according to the water heater instructions. Adjust the thermostat of the electric water heater to 120 ° to 125 ° Fahrenheit (48.8 ° to 51.6 ° Celsius). Fill the tank until the faucet touches. It is very important to have a tank full of water before switching on the energy, because the elements burn and destroy the unit if they are exposed to air. Once the tank is full, turn on the power supply and press the reset button on the panel. The installation of the electric water heater is complete.

Installation of water heater gas can be a slightly demanding task. But it can be very dangerous. If it is installed incorrectly, carbon monoxide can leak into the house and quietly kill everyone when they sleep. Generally, installation of gas water heater requires gas supply, cold supplyWater and flue to remove fatal gases. For those individuals who feel they are on the task, they can complete the installation from 45 minutes to 2 hours.

Once the old water heater has been removed and the water pipe and the gas exhaust ventilation have been removed, it is time to set the new water heater level on site. As with the electric water heater, wrap the threads with the thermal trap with Teflon® tape and attach them to the inputs of cold and hot water. The length of the pipe must then be connected to the unit and water supply - they can be at most stores with home improvements. Finally, connect the gas supply pipe. After the gas was connected and the pipes were tightened, the gas addition of Y can be switched on and the burner must be turned on - either with a match or grilling ignition or a new pilot ignition system. The installation of the gas water heater is completed.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?