What are the best tips for waterproofing walls of the basement?
Waterproofing basement walls can be a difficult procedure, but there are some tips on how to be more successful. Before starting any work on the inner walls, make sure the rainwater drain is sufficiently exhausted from the basement area. Repair of all cracks and holes on the basement walls must be before applying a waterproof coating. If possible, cover the entire wall with a thin layer of hydraulic cement to further seal the moisture. The application of crystalline waterproofing material, followed by two layers of waterproof colors, usually brings the best results.
Successfully water -mate wall walls often require certain preventive measures to be taken away from the structure. Check that all rainwater drainage is directed from the basement area by installing roof gutters and downspauts. An extension pipe for layout may be needed to empty the troughs from the structure. Another way to divert the drain is to gently fold the soil of the basement area. May also be necessaryNot to install a French drain system next to the base for collecting excess water.
Specialized coatings used for the walls of the waterproof work best work on clean and smooth surfaces. The old color should be scraped, ground or removed to ensure the best possible seal. The holes and cracks must be filled with an epoxy patch before applying the coating. Drivery the repair material into the emptiness with a sealant knife to prevent air pockets. Let the repair cure completely before applying a waterproof coating.
Application of a thin layer of hydraulic cement to the entire surface will help seal the moisture with waterproofing of the basement walls. This material extends when it dries and covers small holes and irregularities on the surface. Hydraulic cement can be used separately or with crystalline waterproofing material. This specialized material is penetrating the seals, ktEré walks into the pores of the wall to block the moisture. The crystalline waterproofing material works best when applied to unmistakable hydraulic cement.
After all the walls have been properly prepared, apply two layers of waterproof to the entire surface. Latex waterproofing colors generally adhere to wet surfaces. Lightly fog the walls with water in front of and after each layer of waterproof colors. Use a rigid brush to spread the color with a circular movement and loosen between each coat for at least 24 hours of drying time. Use additional color in the corners and wall base to avoid gaps in coverage.