What is the best method for replacing the cabinet window?

Casement replacement is an easy task that includes measurement for a new window, eliminating the existing basement window and installing a new one in the opening. No special talent, just a few basic tools and materials is needed. The best method to do this involves monitoring simple steps and accurate measurements to prevent the process of changing the window of the cabinet to become frustrating. These measurements can be made to the improvement store where you can buy an exchange window. This step must be taken first, because sometimes the window will have to be ordered, so it should not be pulled out of the old window before the new basement window is ready for installation. The reciprocation saw can be used to cut along the outer edges of the Window frame, allowing the window to be pulled out. Usually it is best for the window to be removed from the outside, but it may depend on the approach available along the outer wall. Some windows in the basement do not have much space for work on the outside, so you need to work with what is available atReplacing the window of the cabinet.

The interior height and width of the hole should be measured and compared with the dimensions of the new window to ensure that it is easy to use. Although it is done, you can use the level and check that the window frame is at the level. If this is not the case, pads can be placed where the frame needs to be adjusted.

The new Casement window can then be inserted into the place. The installation program should make sure that the left -hand pads do not move. The level can be used to adjust the housing to ensure that the cover window is at the level at all times by the opening.

The window can be nailed to a place with nail framing every 6 inches (about 15 cm). If the pad for the existing framework must be installed, the installation program should nailed through them to secure between the new window and the existing framework. With a new cabinet window on site you can take a sharp utility knife and cut off the endings thatEré stands out that protrude around the edge of the window. To this end, a deep wood line should be scored, then it can be along the line.

There are always gaps around the outer edges of any window, so a can of spray foam should be used to fill them. After drying on hard foam, a sharp utility knife can be used to cut off excessive insulation. Cropping the window can then be replaced in inward and by nailing the pieces to a place with the nail finish. Before using any color or stains, the chirp should be applied around the edges.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?