What are the best tips for changing the anode?
The replacement of the anode is essential in the water heater or otherwise the tank begins to corrode after several years. The best tips for replacement of the anode are to turn off the tank power before turning off hot and cold water. Then drain the water from the tank before release and remove the old rod. Use the tape on the thread to prevent leaks and firmly insert the new rod with the key. Before replacing the rod, beware of the tank bleeding, as there is too much pressure in the tank.
Inside each water heater is an anode rod. This rod is made of magnesium and is designed to prevent rusting the tank. This is done by corroding before the tank. If the anode is not replaced, the reservoir will also resoccate. The anode should be replaced every four years to increase the life of the water heater. This is an importnt for safety reasons. When the power supply is on, it is extremely dangerous to try to replace the anode rod because the heating could be activated during the replacement procedure. It is also important to turn off the mountainsand cold water of water heaters.
The drain tap should have an attached garden hose. Drain several gallons of water, allowing the fluid to flow into the external outflow. Make sure the released water is not hot. The entire tank does not have to be released, so turn it off as soon as a reasonable amount of water has been removed.
The next step in the replacement of the anode is to release the fitting of the old rod at the top of the water heater. Use the key to release it and remove the rod by lifting the water from the water heater. Wrap the waterproof tape around the fibers to stop any potential leak. This must be done before adding a new rod.
The new rod should be placed and tighten safely with the key. Slowly turn on the cold water supply and make sure there is no leakage in the fibers. If all is OK, turn on hot water inlet. Restore gas or electricity supply to the tank.
During the exchange of anode Je I important to use the key of the correct size. If you do not do so, this may lead to the rod to adapt too freely. Be careful during discharge, as the water can be hot and can burn anyone who comes into contact with it. Always make sure that the tank is bleeded before removing the anode rod; Otherwise, pressure accumulates in the tank.