What Is an IR Light Switch?

Infrared switches are controlled by induction to turn on and off, including human sensor switches, human sensor lights, microwave sensor switches, micro wave sensors, wireless remote control switches, human sensor switch modules, high-frequency transceiver modules, and home smart products.

Infrared switch

Right!
Infrared switches are controlled by induction to turn on and off, including human sensor switches, human sensor lights, microwave sensor switches, micro wave sensors, wireless remote control switches, human sensor switch modules, high-frequency transceiver modules, and home smart products.
Chinese name
Infrared switch
Product information
24V DC, adjustable intermittent
Performance characteristics
Ultra-low power design, can be connected in series with lights
Terms and Conditions
Do not connect with power during installation.
24V DC, adjustable lighting interruption time, load within 5W, no emergency control, wall mounted) Specifications Model Terminals Emergency Control Zero Line Control Power Load Type Description 01 2 No No 5-60W Incandescent / Fluorescent Lamp [Product Introduction] : This product is an automatic control switch based on infrared sensing technology. During the day, the switch is turned off by light control. When someone enters the infrared switch sensing range at night, the sensor detects the change in the infrared spectrum of the human body and the switch automatically connects The light is on. If the person does not leave, the switch will always be on. After the person leaves, the switch will automatically turn off after a delay. Extends by reducing frequent starts
1. Ultra-low power consumption design, can be connected in series to the lighting circuit of the lamp, and unipolar control energy-saving lamps (fluorescent lamps). Special model can realize strong emergency control.
2. The controllable illumination can be adjusted: as shown in the figure on the right, such as adjusting counterclockwise, the switch can be activated under the environment with stronger illumination; if adjusted clockwise, the switch can be activated under the environment with weaker illumination, That is when it gets darker.
3. The delay time can be adjusted: as shown on the right, the adjustment range is about 20 seconds to 6 minutes. If it is adjusted counterclockwise, the delay time becomes shorter; if it is adjusted clockwise, the delay time becomes longer. [Performance index]: Working voltage: 160 250V (AC) Static power consumption current: <0.3mA Ambient operating temperature: -20 50 Automatic delay time: 20 seconds 6 minutes Control load power: 5 200W Induction Distance: 6 meters. Sensing angle: 140 degree cone angle. Load range. Incandescent lamp / energy saving lamp / exhaust fan. Starting illumination: 5LUX-500LUX (adjustable). Dimensions: 86X86X25mm
Do not connect with power during the installation. It is strictly forbidden to short-circuit the load. Products that control fluorescent lamps and energy-saving lamps. It may take 30-60 seconds to establish the internal voltage before the power is turned on for the first time.
Due to the large starting current of fluorescent lamps and energy-saving lamps, it is recommended that one switch control less than two loads. If the control load is too much, you should consult the manufacturer. In addition, frequent lighting may affect the service life of energy-saving lamps, which is normal.
Do not install the product in a location where hot air flows through. If the control load is a heating light source, the switch should be more than 1 meter away from the light source.
The control of LED lights has special requirements for the product, and you must declare it when purchasing.
2-wire products without zero line and emergency control do not need to consider the polarity of the wiring. Products with emergency control or zero line must be wired as shown in the figure (EM terminal without emergency control product is not connected). See wiring diagram.
When adjusting the light control illuminance and delay time knob, be sure to use moderate force to prevent product damage caused by excessive force.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?