What are the different types of aluminum adhesive?

aluminum materials can be successfully glued together or on other materials using one of the two types of aluminum adhesive. For the general purpose or application of HOBBY, a number of adhesives purchased in a store can be used, such as two -piece epoxides and super adhesives. Projects that require an extremely strong cut-resistant binding will require the use of specially formulated aluminum adhesive types commonly used in hi-tech applications such as the air industry. Aluminum adhesive types that work well in these applications include various two -piece epoxides and any of the better cyanoacrylates or super adhesives. Othe flexible medium strength solutions are any of the double -sided adhesive tapes. Users should keep in mind that the success of any of these adhesives when gluing aluminum relies on the proper preparation of the material.

aluminum binding projects that require high PETensile tensile and skid resistance characteristics require the use of more specialized adhesives designed specifically for use on metals such as aluminum. These aluminum adhesive products are commonly used in specialized areas such as the aerospace industry, where soldering or aluminum welding is not practical. These products can be more difficult to obtain and will certainly be much more expensive than hardware glue, but to ensure much better gluing on aluminum materials. These adhesives should not be necessary if only a slight force is required.

The success of the repair of aluminum or constructions by glue to a large extent depends on how well the surfaces are prepared. Especially the aluminum surface requires special attention before the aluminum adhesive is correctly connected. The surface should be thoroughly cleaned with a slightly soapy solution to remove all dust and dirt, and as soon as it is dry, it should be deleted with ethyl alcohol. When degreasing aluminum, the surface should be wiped in one direction towas prevented from spreading the lubricant back to the surface.

As soon as the surface is clean, it should be slightly rough with fine sand to create a good "key" for glue. All metal dust should then be rinsed with water and the surface thoroughly dried. When it has been done, the adhesive can be used and left for treatment according to the manufacturer's instructions.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?