What Is a Cold Planer?
Automatic ice shaving machine, also known as automatic ice crusher, is a device for making cold drinks in cold drink shops. It is a device used to shave ice cubes into snowflake-shaped crushed ice. Shaved food
Automatic ice shaving machine
- Chinese name
- Automatic ice shaving machine
- Foreign name
- Automatic ice machine
- Automatic ice shaving machine, also known as automatic ice crusher, is a device for making cold drinks in cold drink shops. It is a device used to shave ice cubes into snowflake-shaped crushed ice. Shaved food
- Automatic ice shaving machine, also known as automatic ice crusher, is a device for making cold drinks in cold drink shops. It is a device for shaving ice cubes into snowflake-shaped crushed ice. It is used to produce a variety of tastes and different flavors. Shaved ice food is widely used in the catering industry, hot and cold drink shops, western restaurants, coffee shops, casual snacks and hotels, etc. It is a good product to generate income in the summer season.
- 1. The smoothie machine should be installed on a workbench with sufficient support and at an appropriate distance from the ground.
- 2. Before turning on the power, check whether the power supply voltage used is consistent with the voltage used by the machine, whether the socket meets the safety standards, and the leakage protection switch and the ground wire have been installed. Make sure everything meets the requirements for electricity.
- 3. Before turning on the machine, crush the ice cube to a diameter of about 20 mm before putting it in the barrel. It is better to protrude above the mouth of the barrel. Note that the power switch is turned on first, and after the motor with the power disk is rotated, the plate dynamic pressure cover handle is allowed to be pressed down. At this time, the ice cube is shredded by tightening the blade on the rotary cutter head. However, do not use too much force when pressing the handle of the pressure cover to prevent the motor from being blocked and damaging the motor. And pay attention to the remaining amount after the ice material is reduced, and replenish the new ice material block in time.
- 4. The chopped ice particles flow into the tray through the outlet. Pay attention to the smooth discharge of the discharge port, can not be blocked, otherwise it will cause the cutter head to be stuck and the motor will be burned. If the cutter head is found to be stuck, immediately lift the handle of the pressure cover, turn off the switch, unplug it, and troubleshoot in time.
- 5. The thickness of the ice particles can be achieved by adjusting the height of the blade mouth protruding from the cutter head. When adjusting, first remove the plastic disk that protects the switch device, loosen the screws that fix the elbow, pull out the barrel, and then loosen Remove the cutter head fastening screw, then loosen the blade's compression screw, install it in place according to your requirements, and then install the cutter head etc. back to the original position in order.
- 1. In order to ensure safety, it is not allowed to press the ice block directly by hand for cutting.
- 2. After each use, you must clean it. When cleaning, you should turn off the main power switch, unplug it, and then wipe the water on the machine with a clean towel. After cleaning, remember to lift the handle of the pressure cover.
- 3. No cleaning agent is allowed during cleaning, to prevent the cleaning agent remaining on the machine from causing pollution. Nor can it be washed directly with water, so as to prevent the electrical parts from getting wet, affecting the safe use and damaging the machine.
- 4. The temporary cut-off rate of the motor design of this machine is 80%, to avoid long-term continuous operation. After one hour of continuous work, you should pause for twenty minutes before starting work. This will greatly extend the life of the motor.
- 5. Regardless of related work such as cleaning, maintenance, blade replacement or scum removal, the power should be turned off and the power plug unplugged; the machine is not allowed to run for a long time without load.