What is Drawknife?

DRAWKNIFE, also phoned knives, is a hand -operated tool used to remove the bark from protocols and wood shape, especially when processing green wood. The green woodworking processing deals with wood that is still wet because it must still be dried, whether naturally or with a saw. Dragknife is primarily used to quickly remove excess wood and coarse shape. It is usually not suitable for cutting smooth curves in the wood, although it is often used to use an approximate shape that could be used by another tool such as a beam or lathe.

Drawknife blade is long and shallow with one bevelled or angle side and one flat side. The handles are located at each end of the blade and are usually either perpendicular or continuous with the blade. Drawknife length varies depending on its use; Longer Drawknives is usually used for tasks such as decree protocols and shorter knives are marked for finer wood.

For use DRAWKNIFE,The operator grabs both handles and attracts the knife along the wood towards his body. The section depth determines the pressure down on the handles. Due to lightness and safety, the bevelled edge of the blade is usually tilted up and the blade is rarely displaced from the body. This may lead to a loss of control and potential damage to the user as well as the rapid toard of the knife. Despite these risks, some operators decide to use the tapening book with a bevelled side down as it allows to remove less wood. It is also possible to push the blade from the body, although most people consider this method embarrassing and rather turn the wood around.

shaving wood with a tensile leg is usually done from sitting on a shaving horse. The shaving horse is a bench with a connected clamp. The user will strain the bench and release the leg on the bar below. The bar causes clamping if the wood is closed, holding it in place so that the operator can pull the blade over the wood without moving. The shaving horse also allows the operator to put his legs in order to insert a larger bodyMid weight to pull the blade.

In order to make the wood at the level, the operator should start at the center of work and hate evenly when he pulls Drawknife together. The work should then be cut off and rotated so that the operator can repeat the process from the other side. When creating a concave shape or inner curve, the operator should exert more pressure in the center and less pressure as the blade comes to the body, so the cut becomes less deep towards the outer edge of the work. Convex shapes or outer curves are produced by the opposite process, with a shallower cut in the middle and deeper shaving on the outer edges.

One of the most common uses for Drawknife is stripping the bark. The protocol is locked in a place with a vice or shaving horse, while the operator pulls the blade with consistent pressure and quickly move towards the body and moves the log into the vice as needed. This is often the first step in shaping beams or the production of coarse cylinders, which can then be completed in a lathe. The lathe is a machine with rotatingA component that changes the work and a stationary component that pricks it or cuts it to a smooth, symmetrical shape as it spins. A hand -called Spokeshave tool can be used to complete the same types of work as a lathe such as chairs or rays for bike.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?