What is a flat plate?
The flat plate is a flat part of the concrete. Flat plates are classically used in foundations, although they can also be used in the construction of roads, roads and other structures. Depending on the size and complexity of the flat plate, it may be necessary to design an engineer who is familiar with the limitations and needs of the boards, or it may be possible for one in the afternoon to become a simple project. stiff. The construction of the flat plate is designed to strengthen several directions to withstand tension, such as shifting, earthquake, frost, etc. The inability to fully strengthen the flat plate can cause it to burst or give the weak lines in concrete, which will cause instability.
For some websites, a flat plate is poured. In this case, the site is prepared, concrete forms are set and reinforcement or other materials are laid. Then the concrete is mixed, poured and left to cure before moving to the next phase of construction. The time required may vary significantly, with the size of the mainm factor; The larger the board, the more complicated reinforcement needs they can get, which in turn contributes to the amount of setting. Once the board is also poured, it must also be explored and tested to confirm that pouring was good, without air pockets or other problems that could contribute to a decrease in quality.
In other cases, the flat plate may be prefabricated outside the place and transported to the site if necessary. This can be done when the conditions on the spot do not make it easier to pour, or when it is necessary to carefully check the conditions for the construction of the board. The shipping of the board can be an exception if it is particularly large. Boats, cranes and flat trucks may be required to move from the production site to the installation site.
The flat plate foundation is not without problems. It can settle on an uneven basis, for example, to allow the structure to settle, and during the seismic activity the board foundation cannot withstand if the soils are exposed to liquefaction. Flat plate with mIt can also state the main source of energy inefficiency, because the structures tend to lose heat through concrete.