What is the router of the plater?
The term HONEL router can be used to describe any of the two types of electric tools for wood processing. Both are used for flat material made of wood surfaces either with a view of dimensioning or for the production of square flat surfaces. The first of these tools is the combined router of the router, which usually comes as a set consisting of a replaceable engine with several extensions, including the base of the router and hand hunting. The second type consists of a conventional vertical cut router mounted on a set of glass, which allows the router to be triggered in a straight line over the plate. After the cut is complete, the arrangement of the whole image is slightly proceeded to place the router for further running across the board.
driven wooden processing tool, router chasing is used or shaded by thin layers of wood to achieve the correct size or thickness and for the production of flat square surfaces. Similarly in the theory of operational theories as traditional handmaster of the hand, the router chasing is movingFilling on the face of wood, by taming the blade at a constant height to remove the controlled amount of material. These variants of Holán are usually relatively narrow, so unlike thickness, which can process wide plates in one passage, they must be advanced over the face of wide pieces of wood in a series of even cuts. However, when planning the edges of the boards or doors, the router the router can cut the entire surface in one pass.
There are two types of router plants, the first of which is a combined tool that uses a single interchangeable engine to control several attachments. This set usually includes, among other things, a router base and a Rouper connection. This configuration allows both conventional planning operations and routing simply by changing attachments. Although it is not strictly the only tool as such, these combinations are commonly classified as router planets.
the other router isIt is a bit more complicated and consists of a set of guide rods with a sliding base or sled, as is usually known. The sled is a conventional vertical router equipped with a relatively wide piece. This arrangement is placed through the wood workpiece in such a way that the router moves in a straight line along its length. The sledges and guides are attached to the base that has a manual adjustment type of the lead screw type, which moves the whole wizard and sled arrangement over the width of the board.
For the use of this type of router, the router is lowered and lowered onto the board area. As soon as it starts cutting, it moves along the length of the plate to remove the thin layer of wood. After the cut is finished, the lead screw and sled and the guide move to the position that places the bit of the router adjacent to and only overlaps the last cut. The sequence then moves again over the length of the plate to make another cut; this sequence is repeated until the entire surface of the board is processed. The depth to which the routers are adjustable, whichIt allows a very fine check of the amount of material removed at each passage. This type of cattle is generally more suitable for lowering flat surfaces of the boards rather than on the edge of work.