What is the thread?

Thread Die is a tool bit designed to cut the thread on the outer surfaces of the pipes or bars. These dying are usually hollow circular bits made of hardened tool steel with a series of elevated cutting edges arranged around their inner surfaces. Cutting combs are generally interrupted by several cut -outs that facilitate chip and shaving, ie swarf, removal. Gnieve threads can be either safely held for manual thread surgery in the purpose made on the handle or in the slide -powered thread cutter. Dies reducing threads are always used with a special cutting compound that lubricates the matrix and helps remove Swarf.

fibers cut on the outer surfaces of the pipes and solid bars are usually produced by hand or with a special energy tool using hardened steel tool tools. Typical treatment of thread cutting is circular with cut play equipped with a hollow center. Cutting edges are usually interrupted at regular intervals of cutouts that reduce the Surface cutacThe edges of the edges are reduced by the tension placed on the matrix and helps to remove the chip. The cutting edges of the threads are also tapering towards the first cut to facilitate the desired effort. The fiber sources are usually available in sets with a selection of matrix sizes and often including kicks that are used to cut internal fibers.

The hand -cut fiber is triggered by slow rotation of the thread to the pipe while maintaining the pressure forward on the handle and died. Once the initial part of the fiber is cut, the actual fibers proceed so that the rotary force itself is required to continue cutting. Cutting actions should be carried out in small increments with frequent stops to die half or backwards to break and clear cuts. This process then continues until the desired fiber length is cut off.

Threading Dies used in the cutter of driven threads have similar construction,Although there are often two -piece structures. Systems of cutting these countries are also a little more generous because of the torque involved in energy cutting. All threads died should always be used with an approved cutting paste or a compound that maps to die during cutting and helps remove cuts. Due to the still present possibility of tool fracture and extreme sharpness of newly cut threads, eye and hand protection should also be worn using threads.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?