What is design for production?
In the world of industrial engineering, production design (DFM) refers to the product design method that focuses on how the product will be made. The aim of this engineering method is to create products that can be produced quickly and efficiently. By improving the product production during the design phase, manufacturers can create products that are more cost -effective to produce and thus more profitable. Engineers focus on common factors such as component materials, aesthetics and functionality. In addition to these basic factors, special requirements for tools, production costs, market data and concerns about equipment compatibility must be addressed. Product engineers can develop unique ideas, but the physically insulating concepts is a different matter. Production products must use existing technologies or special tools must be designed. If available tools and technologies are not a task, designing and building new technologies can lead to design for the scope of the projectu too expensive. Any special tool requirements will also require additional employees training for these new tasks, which must be added to the total production costs of the product.
Another main problem in creating production products is the time for the market. This term applies to the time period between the design process until the product is ready for sale. Delay in production, sometimes caused by problems with raw material suppliers, equipment failure and design deficiencies, can cause major losses for manufacturers and retailers. Designing engineers New products for mass production must consider the timeframe needed for economically viable production and predict possible delay.
The common choice in the design of production projects is the use of paired components. Instead of creating similar components that fit only for one way, engineers often propose CasThe dual purpose. In this way, the time to the market can be significantly shortened, as parts for the production of the finished product are prepared in the middle of the two line of the system. An example of this kind of design of a pair component would be the upper and lower part of the Atabéné housing. Using a proposal for production principles during the engineering phase can be different parts identical, but can be used in different ways.