How can I fix the stucco?

Stucco is a popular wall for both outer and inner walls. Many property owners must be repaired at some point on their building, either because of cracks and weather damage or for other repairs and modifications of the building. The property owner with basic tools should be able to do work. The process includes the preparation of the area to be repaired, to apply three layers of stucco patches, the textured final stucco patch patch to match the existing stucco as difficult as possible, and applying any sealant or color that may be desirable. The first step includes cleaning - and cleaning - an area to be repaired. Use a hammer and chisel to remove free stucco from the patch site and then clean all dust or residues from the area. Verify that wire slats and barrier paper behind the varnish are in an acceptable state; If this is not the case, re -place them before using the stucco patch.

Žte type of stucco used in the building during its repair. Buildings that were stubborn in the 18th and 19th centuries were often stucco on the basis of lime. Portland cement Stucco began to gain popularity in the 20th century and eventually replaced the stucco based on lime, which was popular in previous centuries. Portland cement Stucco is heavier than lime -based stucco, and this difference in hardness can cause repair and failure if two types of stucco are mixed when trying to repair stucco.

Stucco Patch Mix is ​​available from many hardware and home stores and is quite cheap. The mixture used to repair the stucco is available dry or pre -mixed and ready for use. Stucco spots can be applied with a sealant knife or wall. A spray bottle for thoughtstcco is also used to prepare for repair.

instead of patch should be damaged by water from the spray bottle before applying the stucco patch. Stucco repair shop should be prepared according to the manufacturer's instructions as soon as the web is repairy ready. The first layer of stucco patch should be approximately 1/4 inches (6.35 mm) to 3/8 inches (9.5 mm) and can be applied with a sealant knife or wall. The surface of this layer of stucco patches should be evaluated with a sealant knife or nail in a diamond -shaped pattern to facilitate the connection with the second layer. The first layer of stucco patch should be allowed to dry a few days before using the second layer.

The second layer is applied similarly to the first layer. The second layer should also be approximately 1/4 inches (6.35 mm) to 3/8 inches (9.5 mm). The surface of the second layer should also be roughened to facilitate the final layer on the second layer. Some people prefer to leave the middle layer for several days to dry the use of the final layer, while others prefer the second layer to be set only to the final layer. The second layer, if allowed to dry fully, will have to be fogged with water from the spray bottle before applying the final layer.

FinalThe stucco layer is applied in the same way as the other layers, except that it should not be stronger than 1/4 inches (6.35 mm). Instead of roughening the surface of the final layer of stucco patch, the textured should be textured to match the existing stucco pattern as close as possible. Stucco patch should be allowed to dry a few days before applying the stucco sealant and performing any image. Stucco may have to dry for so long before applying oil -based paint to the surface.

Mixing manufacturer's instructions and application of stucco patch should be observed. Stucco should not be allowed to dry too quickly when trying to repair the stucco or not cure properly. The repaired Should area will be kept cold and shaded if outside. It may be necessary to spray a new stucco patch with water from the spray bottle every few hours in warm weather to prevent the stucco patch from drying too quickly. Also, stucco repairs should not be done when the weather is coldé or is likely to freeze or freeze, as this also prevents the stucco patch from curing.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?