What are the best tips to remove stucco?
Removing stucco from the wall can be a very difficult process. However, there are some proposals that can help make work easier. The best tips include the placing of the sail under the workplace to capture the falling residues and shorten the cleaning process. If the stucco is completely removed from the wall, a small hammer and a bar will usually bring good results. If the stucco is partially removed to add a window or door, a circular saw should be used for more accurate results. After completing the work, remove the sail to destroy the debris. Do not forget to cover all fine plants near the work area also with a sail. If the steam barrier is damaged during stucco removal, it will be necessary to replace it immediately. Removing stucco can be a very dusty process, so the protective glasses and respirator of the continuation are needed for each worker.
For complete removal of stucco, a small hammer with a short handle to a slight drop should be usedto the surface. Continue to drop until the stucco begins to burst and break into large pieces. Pull as many large pieces as possible. Use a small pry bar to remove any difficult sections. It will probably be necessary to use the pry bar to remove the stucco around the edges of windows, doors and corners.
After the stucco is removed, you will need to remove the wire network. Create a small part of the mesh from the wall and pull the rest manually. The stubborn sections of the network can be removed using the PRY rod. Any remaining nails or clamps associated with wire mesh will have to be pulled out until a smooth surface is reached. If a wooden lathe was used instead of the wire mesh, remove it from the wall of the bar.
For partial stucco removal, a circular saw equipped with a brick blade should be used. Set the blade depth to slightly smaller than the thickness of the stucco to prevent it from cutting into the underlying wire network. If the sparks are present when using the saw, the blade is too deeply cut. CreateThe outline of the pencil in the stucco area and cut it off using the saw. After cutting, remove the part of the stucco with the PRY bar and remove the wire network with the wire cutters underneath it.