What are Bezpilus pedals?
For many years, the clip was the primary pedal system on racing bikes. The tip clip was a metal or plastic cage into which the cyclist slipped into his foot, allowing him to pull the pedals during his pedal, except that he was pushing them down. While this increased power power, toe clips were cumbersome and difficult to get in and out. Therefore, pedals were born without a clip. Clipless pedals also allow a cyclist to pull out on the pedals, but there is no cage for a cycling leg. Instead, the cyclist wears a special shoe with a cradle attached to the bottom; The clupy then surprises to specially designed pedals, similar to ski binding, but much more compact. They work in conjunction with a cyclist shoe that contains a very rigid sole of plastic, carbon or other hard substances. The specially designed cradle then connects to the bottom of the shoe and acts as an intervent between the shoe and the pedal. The pedals themselves without a clip move in shape and size depending on the design of a particular brand, but sentencesThe shine of them is made to effectively shed mud. The first versions of pedals without a clip would be clogged and did not work properly, because the mud was stuck in spring mechanisms while driving.
On most pedals on mountain bikes without a clip, the cradle must slip, pointed, under the bar on the pedal. The cyclist then pushes the heel down and the rear spring loaded the rear bar on the pedal connections to the location on the back of the clip. The cyclist is then basically locked in the wheel. To release the foot from the pedal without a clip, the cyclist must turn the heel out of the wheel to release the football boot from the spring bar.
Some bike pedals on bikes without rails work a little differently. For example, Speedplay pedal systems work in the opposite Manner as the above -described mountain bike pedals. The rods usually attached to the pedal are connected to the cradle of the rider - which is much more voluminous than most of the football boots - and the pedal itselfIt acts in the same way as the above mountain bikes. When the rider pushes the leg against the pedal, the springs that move to the interface are more on the shoe rather than on the pedal. However, edition of pedals without a clip works in the same way: the rider kicks his heel out of the wheel.
Although cyclists are locked in the pedal without a clip, the leg is allowed to move sideways to the side. This is called float, and many pedals now offer a float adjustment that allows the rider to decide how much movement his foot is allowed. But be careful: the reduction of excessive float can be damaging to the knees and not carrying it so much that it could stimulate random release from the pedal.