What is resurfacing?
Resurfacing for Counterbop is a recycling process rather than exchange existing deformation. This strategy allows you to change the look of the board so that it seems to be new. The decision to restore the bathroom or kitchen board is a cost -effective and excellent way to ensure that the final product is exactly what you want for space.
While resurfacing deformation is sometimes referred to as refining deformation, there is a gentle difference between these two approaches. Both strategies cause the older kitchen counter to look new again. However, the process of clarification often involves repairing or re -coating the existing laminate or surface layer of the deformation board, rather than removing the old laminate and connecting the new product to the existing board. Despite the small difference, it is not uncommon for these two terms to be interchangeable.
The actual resurfacing process can use one of two methods. For an aspatiently damaged counter, the usual approach is the complete removal of the laminate and then svPharmaceutical adhesive. By leaving the bare counter, the worst and most amazing is possible, it is possible to spread the uniform coat of the adhesive and set up a new laminate panel in place. The final result is a brand new look of the bathroom or kitchen counter for a fraction of the cost of replacing the entire peak.
The second approach to resurfacing against countermeasures does not require the removal of the original laminate. If the existing laminate cover is in good condition, the house owner can decide to clean the highest thoroughly, and then scratch the surface into the surface with sanding paper. After removing the dust and the residues created by grinding, the cement or adhesive extends in a uniform layer over the surface and a new laminate located directly on the top of the older laminate. This approach tends to take less time and can accelerate peso renovation of the kitchen significantly.
In general, this is a good idea with any project resurfacing deformation thatIt allows overlap with new laminate. This minimizes the chances of random setting new coverage on the spot without achieving complete coverage of the board. After letting the cement or glue dry and cure for one day, the overhang may be cut to allow the edges to flush with the counter itself.
Depending on the size of the kitchen, there may be a good idea for two people to work on the Resurfacing project on the board. This not only shortens the real working hours, but also facilitates the location of the new laminate in exactly the ideal position before the cement begins to bind new coverage.