What are the basics of cb cables?

Civic group or CB, radio and its cabling should be carried out carefully and correctly to prevent the burning of circuits on the radio and the vehicle in which it is installed. CB radio has a choice and uses a frequency belt 27 MHz. CB radio connection includes two types of conductors, red or positive wire and black, which is a negative wire. The fuse should be connected to a positive wire to prevent the system short circuit, especially before installing CB in the vehicle.

There are many different CB cabling foundations that are important because of all variations that exist, but the foundations are quite similar to all. First take a coaxial cable or unshamedled wire and go through the firewall as far as it will need until the battery reaches. The plastic jacket should be removed for a short distance back to achieve a shield to be used as a link to the ground (-). On the stern that the shield should be towed back so the red radio wire CB can be attached toCentral coaxial guidance that is unshamed to. The black radio wire CB is then connected to the shield. The last step in the wiring is to ensure that all connections are safe and clean.

There are other options for CB cabling, such as fuse boxing boxes. In this method, the positive terminal is connected to the fuse conductor and the ground terminal to the ground. Another connection method could be the purchase of a lighter plug. Again, the CB radio base cables such as red for positive and black for negative should be followed. Finally, The plug is inserted into a lighter socket.

CB radio wiring schematics is very difficult to read and understand. It contains different symbols and abbreviations depending on the selection of the owner. There could be different Symmed symbols in schematic, so there is a reference chart for these symbols attached to the manual that should be includedUT with unit. The schemes include logical labeling, for example, "R2 10K" may indicate a specific resistor. Similarly, logical marking is performed for other components such as diodes, capacitors and power supply. The wires are specified rows through which the current flows. The instructions for understanding the symbols of the components used are given in the manual, but can also be found through various books and on the Internet.