What is the tester of a socket?

The socket is a portable electrical device used to test the right operating and cable standards on the plug -out sockets. Usually it is a hand tool that either connects directly to the drawer with pins mounted on the tester or is equipped with a short lead and stopper. Depending on the sophistication of the plinth tester, a number of status indications, including disconnected phases, reverse phases, and the upper end tool, the impedance of the Earth loop may be returned. Most testers show test results on a series of light emitting diodes (LEDs) and some also allow the Earth leak test to perform by pressing the button. The drawer testers are available for the most common industrial and home voltages and pins configurations. They are also the first line of contact between the energy grid and the consumer, thus creating their C Corrected and safe operation of critical consideration. Tests should be ideally performed regularly to check errors but a large number of drawers usually presentIn any single place, it can make it a demanding and time -consuming task. The plinth tester can significantly speed up this process and return reliable and accurate information about the status of the sockets.

These tools are usually small, portable units often not more than a few inch squares. Either they are equipped with a set of pins mounted on the housing that connect directly to the socket or have a short lead and a separate plug. When connected to the socket, the LEDs on the face of the tool gives an immediate mark of a series of relevant conditions. These include the presence of energy on the socket and whether the earth, neutral and live channels are associated with the right pins.

Additional features are available in top -of -the -line plug units, such as the impedance of the ground loop, which is one of the most important factors for the functioning of a safe socket. Other models include the ground failure test button that uIt requires the operator to test units for Earth's leak (ELUS) for proper operation; This is equally critical of the safety function of the socket. Most of the plinth testers are configured for two and three PIN 115-230 volt sockets, although variants are available that can test high -voltage industrial sockets.