What are Adjusters?
The measured value of the production process parameter is compared with the given value. After the deviation is obtained, an output signal is generated according to a certain regulation law to push the actuator to eliminate the deviation amount, so that the parameter is maintained near the given value or a controller that changes according to a predetermined law .
- Regulator, basic definition: regulator, adjuster,
- The principle of weight adjustment used in some automatic transmissions is commonly referred to as "mechanical regulators" or "centrifugal regulators" [1]
- use
- The regulator is generally not allowed to remove the protective cover during use. The normal situation is to perform a comprehensive inspection and maintenance every 200 hours of work. The content is as follows:
- 1. Remove the protective shell and check the contact surface for dirt and burnt. If there is dirt, wipe the contact surface with a cleaner paper. If the contact is ablated or the surface is not flat, which leads to poor contact, generally use "00" sandpaper or sand strip to smooth it, and then wipe it with clean paper.
- 2. Check the firmness of each joint and measure the resistance and resistance of each coil. If it is damaged, it should be repaired or replaced in time.
- 3. Check the closing voltage and reverse current of the interrupter, the limiting voltage of the throttle, the limiting current of the throttle, and the gaps and air gaps of various contacts. If it does not meet the requirements, it should be adjusted.
- 4. Check the adjusted regulator. When starting the diesel engine, pay attention to the indication of the pointer of the charging ammeter. If the pointer of the ammeter still points to the "-" side when the diesel engine is running at a medium speed or higher, this means that the contacts of the interrupter are not open, and the grounding switch should be quickly disconnected; otherwise, the battery, regulator, charging generator, etc. . If the pointer of the ammeter still points to "0" after starting the diesel engine to the rated speed, the adjustments described are not adjusted according to the technical requirements, and the inspection and adjustment should be performed again.