What Are Regenerative Blowers?

The blast regeneration adsorption dryer is an energy-saving compressed air drying device. It adopts the process of ambient air blast regeneration, so it can save a lot of product gas required by the traditional process regeneration.

Blast regeneration adsorption dryer

Chinese name: Blast regeneration adsorption dryer
Throughput: 13-510m3 / min

Working pressure: 0.4 -1.0Mpa
Pressure dew point: -40 (PDP)

Blower Pruge Regenerative Air Dryer

The basic principle of adsorption by the blast regeneration adsorption dryer is similar to the traditional adsorption process. However, the regeneration method is a blast regeneration process, and the process steps include heating and cooling. During heating, the regeneration gas source comes from the ambient air boosted by the blower, and is heated to the regeneration temperature by the heater as the regeneration gas analyzed by the adsorber bed. During the regeneration operation, the regeneration heating gas performs heating analysis on the adsorption bed, and the regenerated gas carries the precipitated water vapor and takes it out of the adsorber. Regenerative blown or taken from its own dry air, after decompression, as regenerative blown cold gas, or air circulation cooling separation as regenerative blown cold gas, the bed is blown to meet the needs of the next stage of adsorption work and avoid air The outlet dew point is unstable due to the presence of bed temperature.

1. Adopt 4h long cycle switching mode, the overall performance of the whole machine is good.

2. Adopting a complete regeneration process, the adsorbent can be completely regenerated, so the dynamic adsorption capacity of the adsorbent is large, and the equipment is economical.

3. Regenerative heating uses ambient air, which has the advantage of energy saving.

4. Multiple interlock protection and alarms, greatly improving the safety and reliability of the device.

5. The outlet dew point is stable, which effectively guarantees the compressed air gas quality.

6. The equipment is integrated and the whole machine leaves the factory.

4. System pressure drop: 0.021Mpa

5. Air consumption: 2% / 0%

6. Switching period: 4h

7. Intake oil content0.1ppm (w)

8. Adsorbent: activated alumina

9. Voltage 380V / 3PH / 50HZ