What is the flat belt?
The flat pulley of the belt is used to operate machines commonly pulled out of a single power source. During the looking flat pulley, it actually has a slight pitch into it and works in accordance with the opposite of the pulleys on the drive shaft; The slice on the machine or on the tool helps to keep the belt on the device and operate without throwing the belt. The typical layer design with a flat belt consists of a very heavy cast iron pulley with a key center opening. This key hole allows the pulley to slip into a fixed driving shaft and kept from slipping in a key way and fastening screw. In order to remove a certain unnecessary weight, and also to help the unit with the remaining cold, most of the roller designs use instead of a fixed steel center in the pulley.
In early production plants, one engine was used to power all machines and tools in Plant. This was achieved by a series of drive shaftsand pulleys passing through the ceiling of the factory. Each workstation had its own drop -down belt and flat belt pulley, which was expelled from the upper driving system and powered specific equipment to each workstation. The worker simply connected the tensioner that brought the belt firmly, and the workstation was driven. It was just like connecting the type of clutch that brought tools and machines to the workstation for life.
The centrally located engine and the use of a flat belt power system allowed a plant to operate without the heat added that would produce individual engines on workstations. This also saved expenses, because only one engine operator had to be used for each work shift. The flat belt pave was also able to slip down the drive shaft to any place required by a new workstation. Changing the diameter of the flat belt pulley, the speed of Machine can be changed. Usually a pulley with a flat belt of larger diameter would causeAnd that the machine is running more slowly, but with added torque, a flat pulley of a smaller diameter would result in a faster machine with less torque.
Some outside agricultural equipment were equipped with a flat belt for powering a stationary machine. Thresher and saws used flat belts taken by a tractor tractor for operation. The belt voltage was modified in these settings by changing the tractor position.