How can I fix a flat wheel tire?

Flat-wheel repair, unlike the purchase of a new one, is something that many do-it-yourselfers can achieve in a short time. Not only does it often save money, but it will reduce the environmental impact. There are several methods for repairing a flat wheel tire, depending on why it is flat. If the tire of the mindless wheel wheels were punctured, there could be an answer to a tire repair set that you can find in most car or DIY stores. If the tire escapes from the area where it sits on the edge, the tire must probably only be reset, which can be achieved using conventional soap dishes or raids. The first step to their repair is to find out where the tire was pierced. Sometimes you can see a nail or screw that protrudes from the tire, but at other times the hole can be a little harder to find.

to insert the piercing hole in the tire flat wheel, the bond canLiving soapy water solution, mixing soap and water in one to one to one. Next, apply this mixture to the tire and add air with an air compressor. Placement of the injection can be found anywhere where the soap mixture begins to bubble and should be marked with a chalk or small strip of tape.

Most tire repair trains come with one or more plugs and two tools to help you repair. A long circular set with a handle, referred to as a tool for reaming tires, is the first to be used. Push it into a tire hole and turn it in and out several times to roughen the edges of the holes. This finds the edges of the hole, which will help the plug in place.

After a flat -wheel hole has been built, the next step is to add a plug. The second tool, which is designed in these sets, often resembles a larger version of the eye of the needle connected to the handle at the other end. The plug should be pushed through this needle and half of it wouldIt was supposed to be hanging on both sides. Push it through the hole until it is about 0.25 to 0.5 inches (0.6 to 1.3 cm) of the plug protruding from the outside of the tire. Kop the tool from the tire, leave the plug inside, trim any excess plug and re -inflate the tire.

If there is a leak around the tire, where it sits on the edge, called beads, it is necessary to reset the flat wheel tire. Before you try, first clean the bead and rim first. After being cleaned, paint the edge with a generous amount of soap, preferably with soap. Inflate the tire using the compressor until the tire beads are built at the edge, which can usually be heard as sharp noise.

If the tire bead fails to set the rim using the soap method, a shock strap or a heavy rope can be used. Carry it, wrap the strap around the tire tread and tighten it. Add air until the bead stops on the edge. Remove the strap and continue to add air, dockD The tire will not be fully inflated.

Some companies began to produce tires a wheel that never goes. These are usually made of polyurethane foam with small air pockets all the time and are sold with or without edge. The tire without a flat wheel is designed to allow you to work in the yard without the risk of inserting the holes into the tire.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?