What is the valve gate controller?

Gate Valve is a mechanical device designed for remote opening and closed valve of the gate. These drivers are known as multiple rotation controls, as it generally takes at least a few complete rotations of the valve stem to open or close the gate. The main gate controls are powered by electric motors that are evaluated to cope with the often considerable weight of the gate, plus tensile forces developed by the fluid passing through the valve. Drives are usually used in unmanned or remote installations that offer long distances or automated controls with one or more valves. Valve gate drive systems include different levels of internal inspection sophistication, but usually include travel and torque sensors that stop the engine when the valve is fully cycled or interconnected.

gate valves are one of the most commonh mechanisms of fluid control in general use and can be found in large numbers in large number of different industries. The basic principle of the valve gate surgery focuses around a flat, round disk or gate that is raised or lowered through wizards or channels to prevent or open the path of fluid flow. This action is achieved by turning a lead screw or stem that passes the corresponding nut built into the gate. This causes the gate to proceed up and down the lead screw, either opening or closing the valve. The lead of the lead screw can be manually applied by means of a circular handle or a valve drive with the gate power supply.

The

drive valve valve drivers are basically relatively simple and consist of an electric motor and a set of position sensors at the basic level. This type of driver is commonly known as a more swivel controller because the average gate valve has at least a few full turns and may take several hundred rotation in the turntableSelf -design of valve. The engines used on the gate valve control are a typical alternating current (AC) types evaluated to conveniently handle the weight of the gate and the pressure of the fluid to which it is exposed. However, one phase and direct current (DC) engines are sometimes used in specialized applications.

The basic operation of the gate valve driver is equally simple, while the engine turns the lead screw to lift or trigger the gate. The end of travel or fully open or closed positions is generally marked with built -in sensors that stop the engine after reaching the end of travel. Cycle activation can come with a kind permission of a remote or local Stop/Start station or be part of an automated system. As a result, the drive valve drive is an ideal application for unmanned installation or those where the valves are located a long way from staff stations.

Main controls

Gate Valve may include relatively sophisticated local controls with programmable operating parameTry, but are more often than relatively simple. However, everything includes the above end of the travel sensors and the torque sensor, which also stops the engine if it gets stuck or blocked. This event generally prevents engine burning and can even operators of a distance of failure.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?