What are the connectors on the board?

Connectors on the board to the board are necessary miniature connectors and sockets that directly connect the power supply and signal between plates with circuits (PCB). They are usually in-line or connector pins in a straight line. Connectors on the board usually use copper alloy that resists oxidation to prevent degraded conductivity over the years. If the PCB is to use too much space in the design of the circuit design, the device can be divided into two or more boards. Connectors on the board on the board can connect between the power supply and the signal between the boards and complete all the connections. A smaller PCB would require production devices that may not accommodate a combined larger PCB. Whether the device or product will be pushed into a single PCB or more PCBS is a question of than other, undesirable signal interconnection, the availability of smaller components and the total cost of the finished device or product. In the production of electronics, it reflects to simplify the testing of huge cost savings. PCB with high density have more tracks and component per unit of surface. Depending on the investment in the sophistication of the production plant, the device or product can be best designed with several connected plates of medium density than one high density plate.

technology through holes allows the third dimension to connect stops and components on PCB. The first PCB can use conductive traces of copper in horizontal and vertical directions along the PCB. Adding multiple layers of boards will be practically several -layer PCB between the two sides of the double -sided PCB. A typical multilayer PCB plate with five layers can be a thickness of less than 0.08 inches (2 mm). Through girls, they have conductive interior surfaces that can carry currents between any two layers of a multi -layer PCB plate.

Modern electronic devices are more reliable and cheaper production thanks to various mature technologies. Production of PCB for multilayer plates used to be a big challenge for hidden connectionbetween traces of two or more layers of copper. Surface technology (SMT) has increased miniaturization efforts due to easy assembly components on PCB or without drilled holes. In the SMT, the robotic equipment applies the glue to the underside of the component before sticking to the PCB component. Lead on anticipated guide components and lead on predicted PCB pads are thinking or re -appearing, and when the PCB is cooled, the soldering process is performed.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?