What are the different types of PCB assembly devices?

To generate modern plates with circuits (PCB) for items as diverse as components of mobile phones and vehicles, many types of PCB assembly devices are required. Typical equipment consists of wire and solder herdsmen, selection and location of the device, reflow of furnaces and optical inspection machines. In addition, the PCB assembly device also includes a test mechanism that ensures that each board works properly. The wire network is cut to a specific pattern for pads and placed over an empty PCB; The solder paste is pushed through openings with open eye on the surface of the board. The resulting formula of PCB solder paste creates the necessary circuit runners for the future location of the electronic component. Employees previously performed this part of the assembly manually, but more modern components are extremely small and more difficult to place them. This specialized type of PCB assembly device ensures that the correct component is placed in a specific orientation to make the circuit function properly.

electronic components are temporarily held on site by solder paste; However, they must be soldered permanently into the PCB by entering the reflow furnace. This extremely hot oven allows the components to follow the melting solder pads. The heat is controlled to a certain extent to ensure that the solder continues to flow while maintaining the structural integrity of each part.

As soon as the board leaves the oven refrow, it must be checked by an optical machine. The components are extremely small; No defects or partial soldering points can be seen in manoko. The worker places the board through this specialized machine to assemble an optical PCB. Light reflects components and circuits and discourages numerous sensors; These sensors can detect the smallest turning point in the perimeter or a non -confident component. Any problems are reported via the machine display for immediate repair or rebuilding.

The latest form of the PCB assembly device that the board mustPassing is a test module. Each PCB has a different testing process depending on the intended use of the board. Usually the employee sets the advice to the test equipment and applies electricity. Each board function will have to be checked in terms of activation and deactivation as well as reliability.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?