What Are the Parts of a Glass Production Line?
Insulating glass production line is a kind of glass deep-processing equipment, which is mainly used for processing and manufacturing instruments for insulating glass.
Insulating glass production line
- Insulating glass production line is
|
|
|
|
|
|
|
|
|
|
|
|
- Insulating glass production line mainly has four sections: feeding section, cleaning and drying section, inspection section and closing section. The four sections are placed vertically with the same inclination, compact structure, economical and practical, high efficiency, and easy maintenance. Cleaning box is
- The plant where the insulating glass equipment is placed should have a gas source and a 380V / 220V (50Hz) AC power supply with a three-phase four-wire power supply configuration, that is, three-phase hot wire, one-phase zero wire; solid concrete floor; industrial tap water source, drainage ditch, site Clean and dust-free.
- 1. Put the insulating glass production line lightly on the installation position, and correctly arrange the position order of each section of the production line.
- 2. Level the fuselage. Adjust the height of the leveling bolts on the base of the machine so that the conveying roller and the supporting surface of the nylon wheel are at the same height. The back-to-wheel on the inclined frame is coplanar, and the sections are relatively parallel, and then the nut is locked.
- 3. Tighten the parts to be connected between the sections, and connect the transmission chain from the feeding section to the cleaning and drying section. Place the fan and water tank correctly, and connect the air pipes and water pipes according to the water system and air system diagram.
- 4. Comprehensively check whether all the fastener connection parts of the machine are loose due to transportation vibration and tighten them piece by piece (especially whether the connection points of each terminal are loose).
- 5. The ground wire should have a soft copper core yellow-green insulated wire with a cross-sectional area of not less than 4 square millimeters.
- 6. Connect the air source and check whether the pipeline is unobstructed or damaged. Air source pressure is required to be 0.6 0.8Mpa.
- 7. Turn on the power and test whether the rotation direction of each motor is correct and whether the transmission sprocket of each section is flexible and stable.
- 8. Clean the whole machine and organize the working area.