What are Turka fat?

The

ugly tusks are usually found on sets of car wheels. The automotive deposit consists of an outer and inner war bearing together with a tutevka for fats. The rollers' bearings are full of grease when they are installed and that the fat is melted as the wheel spins. The fat gasket consists of a soft rubber or a nylon ring incorporated into a metal housing, which is installed in the axle cover or wheel hub and is located near the axle or spindle. When the grease has melted due to the rubbing of the wheel, the sealing of the grease prevents leakage of liquid fat from the bearing housing.

In the first years of the car, a seal was made of skin. The leather fat gaskets were reasonable and successful partly due to relatively slow wheels. As the car evolved and the speed of the wheels increased, it turned out that the sealing of leather grease was insufficient. An improved version consisting of a rubber seal associated with a metal body proved to be successfully sealing bearings, which fromabraits grease in leakage from the bearing assembly. Some vehicles produced before 1950 used the seals from the rope. Rope http://www.wisegeek.com/back/article.htm?id=128806seas was slightly successful in the bearings seals.

When installing a new wheel bearing, it is wise for individuals to also replace the fat gasket. The smallest nickname or handling of fat seal could result in a defective seal and grease that would find the way out of the bearing. Signs of defective seals are streams of grease running from the center of the wheel to the outer edge of the wheel or tire. In the case of defective inner seal, the smell of hot or burning grease is often a sign of the problem when braking. This happens when escaping to the lubricant for the brake rotor and is heated by friction of the brake application.

replacement is as easy as curiosity from its location from its location and clicking a new seal to the position. It is necessary to be inThe nitter edge of the new seal is covered with light oil or grease before installation on axle or spindle. This prevents overheating of the gasket, resulting in a distorted seal. The distorted seal is not suitable close to the axle or spindle and allows grease to escape from the bearing.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?